Unicont SPb PCH-205 Spécifications télécharger pdf (Page 20)

Unicont SPb Ltd Operating manual BCP-136

Page 20

 press ▲ and ▼ buttons simultaneously and hold them pressed for 5 seconds, until

"Prt" message is shown on the left indicator.

 by means of ▲ and ▼ buttons select "SEt" message on the right indicator.

 press ENTER to confirm the selection ("SEt" message is shown on the left

indicator).

 by means of ▲ and ▼ buttons select the port ("CH1" or "CH2" message shown on

the right indicator, which corresponds PORT1 and PORT2 of the panel, respectively),

for which it is necessary to specify a connection type.

 press ENTER to confirm the selection.

 by means of ▲ and ▼ buttons select the necessary parameter: AL, ALd, Cth, Uh,

or UL. Accessible parameters are described in Table 7.

 press ENTER to confirm the selection

 by means of ▲ and ▼ buttons set the necessary value (ref. Table 7).

 press ENTER to confirm the selection

 Press MENU button until the panel is switched to the primary operating mode.

8.3.5. Charging current setting (enter the main menu)

In order to set the necessary charging current, perform the following actions:

 press MENU button until "I" message is shown on the left indicator.

 by means of ▲ and ▼ buttons set the necessary charging current.

 press ENTER to save the specified value in the nonvolatile memory of the battery

panel.

8.3.6. Charging voltage setting

In order to set the necessary charging voltage, perform the following actions:

 press MENU button until "U" message is shown on the left indicator.

 by means of ▲ and ▼ buttons set the necessary charging voltage.

 press ENTER to save the specified value in the nonvolatile memory of the battery

panel.

8.3.7. Indicator brightness adjustment

Brightness can be adjusted when panel operates in the standby (primary) mode.

1. Decreasing the brightness

In order to decrease the brightness by one level, press ▼ button. In order to decrease

it by several levels (or down to the minimum), press this button multiple times or hold it.

2. Increasing the brightness

In order to increase the brightness by one level, press ▲ button. In order to increase it

by several levels (or up to the maximum), press this button multiple times or hold it.

Note! Upon each activation (startup) of the battery panel the brightness is set to the

maximal level regardless of the settings made prior to the last switching off.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Unicont SPb PCH-205 Spécifications Page 20