Unicont SPb PCH-205 Spécifications télécharger pdf (Page 8)

Unicont SPb Ltd Operating manual BCP-136

Page 8

6. Controls and indicators

Battery panel is equipped with the following controls and indicators:

 control buttons,

 selected battery LEDs (BAT1/2),

 alarm LEDs (BAT ALARM 1/2, AC ALARM 1/2),

 two digital LED indicators.

Arrangement of indicators:

Fig. 2 Arrangement and general purpose of indicators.

o Control buttons are used to select battery 1 or 2 to display its parameters by means

of the digital indicators, acknowledge alarm sound signals, perform the lamp test, adjust

brightness of LEDs and digital indicators. Menu navigation buttons make it possible to configure

CH-105 and PCH-205 (connected to digital interfaces) and to adjust shunt and alarm settings

(control button purposes are summarized in Table 3).

Table 3. Purposes of BCP-136 control buttons

Button Purpose

selection of main menu items (ref. section 8.3).

▲ and ▼

adjustment of LED brightness, selection of menu item values

ENTER

saving (entering) of the selected menu item value (ref. section 8.3).

BAT 1/2

selection of battery 1 or 2 (ports PORT1 and PORT2) for indication.

MUTE/TEST

switching off (acknowledging) of alarm sound signal (ref. section8.3.9), testing of

LEDs, indicators and the beeper (the test mode, ref. section 8.3.8)

o Alarm LEDs BAT ALARM and AC ALARM (ref. Fig. 2).

Table 4. Purposes of state indication LEDs.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

Pas de commentaire

Unicont SPb PCH-205 Spécifications Page 8